Water Leak Detection   •   Oil Leak Detection   •   Environmental Alarms
t: +44 (0)1249 715698
e: enquiries@aqualeak.com

WG1 Single Zone Major Water Leak Detector

WG1 BREEAM Water Leak Detector

WG1 Major Leak Detection

The WG1 specifically designed to help meet the requirements of BREEAM WAT02 and WAT3 major water leak detection criteria where the mains cold water enters a building at more than one point or where the outside wall of the building forms the property boundary. Designed as a single zone unit it can be used together with the WG2 leak detection system to cover any additional points where the mains cold water enters a building, after the initial point of entry.

  • Designed to help meet all BREEAM requirements for WAT3 where the outside wall of the building forms the property boundary.
  • Designed to help meet all BREEAM requirements for WAT3 when the mains cold water enters the building at more than one point.
  • Designed to help meet all BREEAM requirements for BREEAM WAT02 for monitoring of water consumption in the building.
  • Optional latching valves are available to switch off the water supply should a leak be detected.

The WG1 uses a single turbine water meter positioned on the main cold water pipe just after it enters a building. A pulse unit attached to the water meter signals the amount of water passing through and sends this information to the WG1. The WG1 is fully programmable and can be set to monitor a specific amount of water at a specific time of day. Should this set amount be exceeded at any time, the system will go into alarm.

Typical applications include schools, hospitals, prisons, commercial units, public buildings, office buildings and leisure centres.

It activates when the flow exceeds the pre-set maximum for the pre-set period of time. It can identify different flow and therefore leakage rates and is programmable to suit the owner/occupiers water consumption requirements.

Specification
Zones covered: 1
Dimensions: 300x260x130mm
Pipe sizes covered: 15mm – 200mm
Power Supply: 240VAC
Pulse Splitter: Yes
Meter fitting: up to 40mm BSP above 40mm flange

Accessories

Water Meter

Aqualeak supply turbine water meters with pulse reader units which output at the correct parameters for the WG1 and WG2 water leak detection control panels.

Meters are available in sizes between 15mm and 200mm. Water Meter Details

BRE Global and its affiliates do not endorse or certify any individual products and reserve all rights.  Certification that a product meets BREEAM requirements is provided by a BREEAM assessor based on its use and application at any individual site.

To request more information please complete the form below.

Our experienced team are here to help. Contact us to discuss your application.
+44 (0)1249 715698
Mon - Fri
8:00 am - 5:00 pm
copyright 2017 Aqualeak Detection Ltd
web design by intechnia